Repair Chevrolet Repair Toyota Repair Honda Repair AvtoVAZ Repair Mercedes-Benz Repair BMW Repair Opel
Home  |  Contacts  |  Sitemap  |    
English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
AudiManual.ru
 
 
 
 
 
 
 
 
 
 
  • AUDI 80
  • AUDI 100
  • AUDI A3
  • AUDI A4
  • AUDI A6
  • AUDI A8
  • AUDI Q
  • OTHER
  • ARTICLES
B4 (1991-1996) B3 (1986-1991) B3 (1986-1991, petrol) B2 (1979-1986)

Technical characteristics of the brake drive (Audi 80 B2)

  • Home
  • Audi 80
  • B2 (1979-1986)
  • Chassis
  • Brake system
  • Technical characteristics of the brake drive
            0
Table of contents: Master brake cylinder ↓ Vacuum brake booster ↓ Pressure regulator ↓

Master brake cylinder



Master brake cylinder with two coaxial pistons.

Brand: ATE or FAG.

Diameter of the main brake cylinder, mm: 20.64.

Piston stroke, mm:
  • primary circuit: 14.5;
  • secondary circuit: 12.5.

Vacuum brake booster



Brand: Bendix Mastervac, ATE (Teves) or FAG (Shiter).

Piston diameter, inches:
  • cars with carburetor engines before 1985 model year: 7;
  • vehicles with fuel-injected engines before model year 1985 and all vehicles since model year 1985: 9.

Distance between the center of the pushrod fork hole and the support surface of the brake booster, mm:
  • before 1985 model year: 189;
  • since 1985 model year: 222.5±0.5.

Pressure regulator



The regulator regulates the pressure in the hydraulic drive of the rear wheel brake mechanisms depending on the load on the rear axle of the vehicle.

Pressure regulator test data*

Pressure regulator test data*

* The test is carried out on a loaded vehicle with a driver and a full fuel tank.

**The numerator shows values for vehicles up to model year 1985, and the denominator shows values for vehicles from model year 1985 onwards.

(The original article is available on the website: AUDImanual.ru)
The article was checked by auto expert Georgy Rodionov
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:
Previous articles
Audi 80 B2: Brake system
Next articles

Technical characteristics of the rear wheel brake mechanisms
Technical characteristics of the front wheel brake mechanisms
Design and technical characteristics
Technical characteristics of the parking brake system
Tightening torques of main threaded connections, kgf.m
Replacing the front brake pads of the ATE brand
Disassembly and assembly of the front wheel brake mechanism of…


Similar articles on other Audi car models:
Technical characteristics of the brake system Audi 100 C3 (1982-1990)
Checking the brake system Audi A3 Type 8L (1996-2003)
Technical characteristics of the car Audi A4 B5 (1994-2001, petrol)
Technical characteristics of the brake system Audi A6 C4 (1994-1997)
Bleeding the hydraulic brake drive Audi A8 D2 (1994-2002)
Electromechanical parking brake Audi Q5 Type 8R (2008-2017)
Engine number and characteristics Audi A2 (1999-2005)
Link to this page in different formats


Visitor comments

No comments yet


How much will 19 + 49 =
       



80(B4, 1991-1996) 
  • General information
  • User manual
  • Maintenance
  • Troubleshooting
  • Power unit
  • Engine
  • Cooling system
  • Heating and ventilation
  • Petrol injection
  • Diesel fuel system
  • Fuel system
  • Exhaust systems
  • Ignition system
  • Transmission
  • Clutch
  • Car gearbox
  • Chassis
  • Brake system
  • Suspension and steering wheel
  • Body
  • Body and trim
  • Electrical equipment
  • Electrical system
  • Electrical circuits
 
80(B3, 1986-1991) 
  • General information
  • Repair characteristics
  • Maintenance
  • Power unit
  • Gasoline engine
  • Diesel engine
  • Engine lubrication system
  • Fuel system (gasoline)
  • Injection system (gasoline)
  • Fuel system (diesel)
  • Ignition system
  • Cooling system
  • Heater
  • Exhaust system
  • Transmission
  • Clutch and gearbox
  • Chassis
  • Steering
  • Brake system
  • Car suspension
  • Body
  • Body elements
  • Electrical equipment
  • Power devices
  • Lighting and appliances
  • Electrical circuits
 
80(B3, 1986-1991, petrol) 
  • General information
  • User manual
  • Maintenance
  • Power unit
  • Engine 4-cylinder
  • Engine 5-cylinder
  • Cooling system
  • Fuel and exhaust systems
  • Ignition system
  • Transmission
  • Clutch
  • Mechanical transmission
  • Automatic transmission
  • Drive shafts
  • Chassis
  • Brake system
  • Suspension
  • Steering
  • Body
  • Exterior
  • Interior
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
 
80(B2, 1979-1986) 
  • General information
  • User manual
  • Power unit
  • Engine FZ
  • Engine EP, YP, YZ, DT, DS, DZ
  • Transmission
  • Clutch
  • 4 speed gearbox
  • 5 speed gearbox
  • Front wheel drive
  • Chassis
  • Front suspension
  • Rear suspension
  • Steering
  • Brake system
  • Electrical equipment
  • Equipment and devices
  • Electrical circuits
 
AudiManual.ru © 2017-2026 · Mobile version · Feedback · Sitemap: EN BG BY UA RS HR RO PL SK HU · Site search · News and articles
80 B2 · 80 B3 petrol · 80 B3 · 80 B4 · 100 C3 diesel · 100 C3 petrol · 100 C3 · 100 C4 petrol · 100 C4 · A3 Type 8L · A4 B5 petrol · A4 B5 · A4 B6 petrol · A4 B6 · A4 B7 · A4 B8 · A6 C4 · A6 C5 · A6 C5 Allroad · A8 D2 · Q5 Type 8R · Q7 Typ 4L · Audi A2 ·
This site uses cookies 🍪. Click the button to accept this fact.