Crankshaft 1. Bearing insert, for cylinder block with lubrication groove, mark previously used inserts, but not on the working surface; 2. Cylindrical gear wheel; 3. Bearing insert, for cover without lubrication groove, mark previously used inserts, but not on the working surface; 4. Crankshaft axial locking insert, for bearing 3, various designs for cylinder block and bearing cap; 5. Bolt, 65 Nm + 90°, replace. To measure radial clearance, tighten to 65 Nm, but do not tighten further; 6. Bearing cover, bearing cover 1: from the pulley side, bearing cover 3 with recesses for adjusting washers, installation position: retaining protrusions of the liners installed in the cylinder block and cover must be located opposite each other; 7. Crankshaft, with balance shaft module gear wheel