- 1. Gas stop. To remove, slightly lift the spring stop -arrow- and remove the gas-filled shock absorber from the ball head bolt. When installing, make sure that the position is correct: the gas stop tube on the side of the lid must be suspended
- 2. Hood
- 3. Ball pin, hood side, 21 Nm
Support or secure the hood to prevent it from falling. Use a small screwdriver to slightly lift the spring stop -arrow- and remove the gas-filled shock absorber -1- from the upper ball bolt -2-.
Repeat these steps for the lower ball head bolt.
Installation
After completely removing the gas stop, during installation, ensure that the position is correct: the gas stop tube should be suspended from the side of the lid. Press the gas-filled shock absorber and snap it onto the ball head bolts.
Visitor comments