Removing the drive lever cover 1. Bottom pad "pillars -A-"; 2. Drive lever cover. Before dismantling, remove only the cable rod in the coupling in the motor. compartment Release the retaining clips from the drive arm. Remove the trim from the side of the drive arm; 3. Drive lever; 4. Mounting bracket. Press in completely with a click
Removing the drive arm 1. Sheathed cable. Fix the cable stop in the sheath in the support bracket, as shown in the figure; 2. Drive arm support bracket. The drive arm cover has been removed. Overlay "pillars -A-", below, removed. Unscrew the bolts -3- and remove the cable tie -1-; 3. Bolts. 2 Nm; 4. Clamp; 5. A-pillar
Laying the cable in the sheath in the cabin
Place Ypoc in shell -1 - to "A-pillar", as it shown on the picture. The nozzle -2- should be pressed against "A-pillar" in the direction from the salon.
Laying the cable in the sheath in the motor. compartment
Lay the sheathed cable -2- coming from the passenger compartment to the radiator frame along the upper side member -3-. Insert coupling -4- into radiator frame.
Visitor comments