Scheme of installation of cable with hood lock shell 1. Trunk lid lock. Move the hood up or down to adjust it; 2. Hood lock cable. Removal: disconnect the sheathed cable from the coupling. Release the sheathed cable from bracket "7". Pull the sheathed cable to the engine compartment. Installation: in reverse order; 3. Clutch for cable traction. Install the clutch clamp on the side of the bracket "8" of the radiator frame. Before removing the radiator frame and when removing the release lever, disconnect the cable in the sheath; 4. Rear cable traction of the hood lock. Cable in a sheath, going to the drive lever in the passenger compartment of the car; 5. Nozzle. When installing, ensure that it fits correctly; 6. Drive lever. Disconnecting the cable in the sheath; 7. Hood lock release lever. Remove the adjustment lever cover; 8. Electrical cable. Route the electrical cable and the hood lock cable through the radiator frame as shown in the figure; 9. Cable tie
Cable traction coupling 1. Cable traction, rear. Cable traction to the drive lever. When removing, first pull it out of the coupling in the rear direction; 2. Front cable with coupling. To unlock, remove the clamp from the radiator frame and do not completely remove the cable rod from the clamp. Open the coupling and lift the front cable rod with the nipple from the coupling; 3. Radiator frame; 4. Clamp. After installing the cable traction, install it on the side of the radiator frame
Connecting the cable traction to the hood lock 1. Cable in a sheath, front. Insert the nipple for the cable traction into the drive lever on the hood lock. Push the cable with the guide from below into the hood lock; 2. Boot lid lock. Secure the cable guide in the sheath at the bottom of the hood lock; 3. Radiator frame; 4. Cable in a sheath for right-hand drive vehicles; 5. Cable tie. Secure the wire and cable to the radiator frame using a cable tie
Installing a sheathed cable into the hood lock
Install the nipple of the cable in the sheath "2" in the drive lever "arrow" of the hood lock "3". Fix the cable in the sheath with the guide "1" from below in the hood lock.