1. Selector cable drive to selector corner. Lubricate in the area of the boot/clamping element with silicone grease "G 000 405 A2"
2. Place the shift cable on the selector guide and lubricate the area of the boot/clamping element with silicone grease "G 000 405 A2"
3. Lock washer
4. The backstage housing
5. Locking clamp, do not damage when removing cable drives
6. Clamping elements, always subject to replacement, clip into the boot, lubricate the passages for the cables with silicone grease "G 000 405 A2"
7. Dust cover
8. Wiring harness mounting bracket (if available)
9. Bolt, 20 Nm, cable counter supports
10. Cable stop
11. Attachment for fastening the cable counter support on the gearbox
12. Spacer
13. Nut, 10 Nm, fastening bracket to cable counter support
14. Cable lock for the shift cable on the gear selector. Replace after removal
15. Nut, 20 Nm, self-locking. Always replaceable
16. Gear shift lever with counterweight. Install so that the protrusion between the teeth fits correctly on the shift shaft, after installation, adjust the gear selector linkage
17. Crawler. Lubricate with grease "G 052 142 A2"
18. Intermediate gear selection lever
19. Lock washer
20. Support sleeve
21. Cable lock of the gear selection cable on the intermediate gear selection lever. Replace after removal
Mounting position of gear shift lever, intermediate gear selector lever and locking bolt
1. Gear shift lever with counterweight
2. Locking pin, for adjusting the switching mechanism
3. The intermediate gear selector lever is fixed with a slider in the guide of the gear shift lever "arrow"
Installing the gear shift lever
When installing the gear shift lever, ensure that the spline "arrow A" fits into the protrusion between the teeth of the shift shaft "arrow B".
Removal the cable retainer from the gearshift lever or intermediate gear selector lever
Removed cable clamps should be replaced.
Unfasten the lock of the gear selector cable "A" and the gear shift cable "B" with an open-end wrench "1" from the gearbox. "1" is a regular 13 mm wrench.
Installing a new cable retainer on the shift lever or intermediate gear selector lever
Removed cable clamps should be replaced.
Apply a small amount of polyurea grease "G 052 142 A2" to the spherical insert of the locking device of the gear shift cable "A" and the gear selection cable "B". There should be no grease on the seals of the "arrow" outside the spherical inserts.
Place the gear shift cable on the gear shift lever and the gear selection cable on the intermediate gear selection lever "arrows".
(This article was copied from an online resource audimanual.ru)