Table of contents: Information ↓ Replacement of components ↓
Information
1. The system contains a bleed valve, a carbon adsorber and a set of various connecting vacuum hoses.
2. The bleed valve is installed in the right corner of the engine compartment, in the vacuum line between the carbon canister and the intake manifold. The canister is secured under the front right wheel arch, behind the mudguard in front of the "A" pillar.
Replacement of components
Bleed valve
3. Turn off the ignition, disconnect the wiring connector from the valve.
4. Loosen the clamps and disconnect the vacuum hoses. Remember the valve installation method.
5. Installation - reverse procedure.
Carbon adsorber
6. Apply the handbrake, raise the front of the car and install safety stands. Remove the right front wheel.
7. Partially remove the right locker to gain access to the adsorber - see chapter 11.
8. Disconnect the vacuum and bleed hoses, remembering how they were connected.
9. Loosen the mounting screws and remove the adsorber (Fig. 2.9).
10. Installation - reverse procedure.
(The original publication in its entirety is posted on the website audimanual.ru)