Cars without airbag (Airbag)
Removal
Disconnect the battery ground cable.
Remove the steering wheel.
Loosen the bolts securing the tension clamp to the switch. To do this, insert a Phillips screwdriver diagonally from below into the opening in the trim.
Note: the screwdriver may be difficult to insert due to the wiring harness. In this case, slightly increase the angle of the screwdriver and move the motor past the terminal to the screw, or unscrew the 2 lower screws securing the upper trim and remove it.
Pull the switch on the steering wheel up, slightly turning it around the steering shaft
Disconnect 2 connectors, disconnect 1 cable connector.
Installation
Place the steering wheel switch all the way onto the control shaft. To make it easier, first insert a screwdriver into the clamping screw.
Tighten the clamping screw.
Install the steering wheel.
Connect ground to the battery.