2. Remove the air filter as described in Chapter 4.
3. Disconnect the accelerator cable and throttle cable as described in Chapters 12 and 13.
4. Disconnect the fuel inlet hose.
5. Mark the location of the vacuum tubes, then disconnect them (photo).
6. Mark the location of the wiring, then disconnect it (photo).
7. Unscrew the clamping bolts and lift the carburetor from the intake manifold (photo). If necessary, unscrew the flange.
8. Installation is carried out in reverse order on a clean contact surface. Replace the flange if necessary. Tighten the mounting bolts evenly.