- Bolts* of fastening of a head of cylinders (on a cold engine): 1st reception: 4.0; 2nd reception: 6.0; 3rd reception: 7.5; Step 4: turn 90°.
- Bolt of fastening of a gear pulley of a cranked shaft: 8,0.
- Nuts of hairpins of fastening of cases of bearings of a camshaft: 1,8-2,1.
- Bolt of fastening of a gear pulley of a camshaft: 8,0;
- Nut of a hairpin of fastening of a belt tensioner: 4,5;
- Bolt of fastening of a gear pulley of an intermediate shaft: 8,0;
- Bolt of fastening of covers of radical bearings: 6,5;
- flywheel bolt (pre-apply special glue to the thread): 7,5.
- Connecting rod cap bolt nut: 4.5.
- Bolts M12 of the gearbox to the engine: 5.5.
- Bolt of fastening of an arm of a suspension bracket of the power unit to the block of cylinders: 3,5.
- Bolt of fastening of a cover of a head of cylinders: 1,0;
- Bolt of fastening of a pulley of a cranked shaft: 20,0;
- Water pump mounting bolt: 2.0;
- Starter mounting bolt: 2.5.
- Oil pressure sensor: 1.2;
- Oil drain plug: 3.0;
- Spark plugs: 3.0.
* When installing the cylinder head after repair, install new hex socket head bolts.
Visitor comments