Climb
Using the jack from the driver's tool kit
Road jack installation locations are indicated by markings on the underside of the body at the front and rear on both sides of the vehicle. The jack leg must be installed so that it rests rigidly on the two vertical edges of the spar.
Using a mobile garage jack or lift
When lifting the right or left side of the car in the front of the car, the jack or lift levers are brought under the longitudinal reinforcement of the body floor, in the rear part - under the vertical reinforcement of the side member near the mark.
When lifting the front of the car, the levers of the jack or lift are brought under the gearbox amplifier into the middle part of the subframe, while lifting the rear of the car - under the middle of the rear suspension beam.
Towing
The tow rope is attached to two eyelets located at the front and rear on the bottom of the vehicle. The eyelets must only be used for towing the vehicle, not for lifting the vehicle directly or by any means.
Visitor comments