Removal the rear brake disc (Audi Q5-8R)

Raise the vehicle. Remove the wheels. Disconnect the brake hose and electrical wiring from the combined bracket on the wheel support. Remove the brake caliper with the pads and brake bracket. Do not hang the brake caliper with the brake bracket from the brake hose, but secure it to the body with a suitable cable tie or wire. Do not load the brake hose with the weight of the brake caliper. Loosen the locking bolt "arrow" from the brake caliper, while holding the brake disc from turning. Remove the brake disc from the wheel hub. When removing the brake disc from the wheel hub, do not tilt the brake disc.

Installation

Replace the screw. Before installation, clean the brake disc, wheel hub and mounting surfaces. Place the brake disc on the wheel hub. When placing the brake disc on the wheel hub, do not tilt the brake disc. Screw in the locking bolt "arrow" and tighten it. Install the brake caliper with the brake bracket. Use a standard extension nozzle to tighten the lower bolt "16". The extension nozzle is not required to tighten the upper bolt "17". The mudguard liner should be slightly pressed to the side. Secure the brake hose and electrical wiring in the combined bracket on the wheel support. Check that the brake hose and electrical cable are correctly secured in the bracket of the wheel bearing housing. Spontaneous separation of the brake hose and electrical cable from the bracket is unacceptable. Install the wheels. Lower the vehicle.

(The original text of the material can be found on the website: audimanual.ru)