Table of contents: Removal the front wheel speed… ↓ Installation ↓ Removal the rear wheel speed sensors… ↓ Installation ↓
The figure shows the front view from the right.
- 1. Speed sensors G45/G47
- 2. Hexagon socket head cap screw. 9 Nm
Removal the front wheel speed sensors G45/G47
The toothed disk/rotor is built into the corresponding unit of the wheel bearing and cannot be replaced. Raise the car. Unlock and disconnect the plug connector of the speed sensor. Unscrew bolt "2". Remove the speed sensor from the wheel bearing housing.
Installation
Installation is in the reverse order, taking into account the following: before installing the speed sensor, clean the inside of the hole and lubricate the sensor around the perimeter with plastic grease G 000 650. After installing the sensor, turn the steering wheel right and left until it stops and make sure there are no obstructions for the speed sensor wire. Lower the car.
Removal the rear wheel speed sensors G44/G46
The figure shows the rear left view.
- 1. Speed sensors G44/G46
- 2. Hexagon socket head cap screw. 9 Nm.
The toothed disk/rotor is built into the corresponding unit of the wheel bearing and cannot be replaced. Raise the car. Unlock and disconnect the plug connector of the speed sensor. Unscrew bolt "2". Remove the speed sensor from the wheel bearing housing.
Installation
Installation is in the reverse order, taking into account the following: before installing the speed sensor, clean the inside of the hole and lubricate the sensor around the perimeter with plastic grease G 000 650. Lower the car.