Withdrawal
Remove the rear ventilation grille A from the center console downwards (see iris. 12.74). To do this, pull out the four wire clamps.
Disconnect the electrical connector for the cigarette lighter, rear ventilation grill lighting and rear seat heating.
Pull out connector B (pic. 12.74) from the air channel
If available, remove the middle armrest.
Loosen nut 3 (pic. 12.73).
Pic. 12.73. center console
1 - center console,
2 - cover,
3 - nut, 10 Nm,
4 - gear lever handle,
5 - cuff of the gear shift knob,
6 - center console insert,
7 - bolts, 5 Nm,
8 - bolt, 55 Nm,
9 - automatic mirror adjustment button,
10 - swing pad of the parking brake lever,
11 - fixing protrusion,
12 - console anchor bolt,
Remove cover 2 (pic. 12.73).
Remove bolt 8 (pic. 12.73).
Manual Transmission. Unscrew the handle from the gearshift lever and remove the cuff 5 upwards (pic. 12.73).
Automatic transmission. Move the gear lever to the down position.
Remove the center console insert towards the top.
Loosen two bolts 7 (pic. 12.73).
Remove the parking brake lever cover.
Remove center console 1 upwards (pic. 12.73) and disconnect the electrical connector from the automatic mirror adjustment switch.
Pull the parking brake fully.
Remove swing upholstery 10 (pic. 12.73) from the fixing ledge 11.
Raise the center console above the anchor bolt 12 (pic. 12.73) and pull down.
Remove the center console through the handbrake lever.
Installation
Place the center console on the front of the parking brake lever. At the same time, make sure that the air ducts fit correctly.
Hang the oscillating trim 10 (pic. 12.73) on the fixing ledge 11.
Connect the electrical connector to the automatic mirror adjustment switch.
Install the parking brake lever trim.
Bolt the center console.
Attach the insert for the shift knob.
Manual Transmission. Insert the gear lever collar and screw the knob onto the gear lever.
Place the lid on the storage shelf.
Insert the connector for the lower air channel.
Connect the electrical connectors to the cigarette lighter, ventilation grill lighting and rear seat heating.
Insert the rear ventilation grille into the hole.
If the middle armrest is dismantled, mount it.
Visitor comments