Table of contents: Removal ↓ Installation ↓
Removal
1. Remove the steering column switch assembly.
2. Disconnect the immobilizer reading coil plug and plug 1 of the ignition switch (see illustration).
4.0. Ignition switch terminal designations:
15 - terminal 15
30 - terminal 30
50 - terminal 50
50b - terminal 50b
75 - terminal 75
86s - terminal 86s
P - parking position
3. Remove the protective varnish from the heads of both ignition switch mounting bolts (see arrows in illustration 4.2).
4. Loosen the ignition switch mounting bolts and then carefully remove the switch from housing 2 on the steering column (see illustration 4.2).
4.2. Disconnect the immobilizer reading coil plug and plug 1 of the ignition switch
Installation
The ignition switch is installed in the reverse order of removal.
Caution: When installing, make sure that the ignition switch and the ignition switch are in the same position, for example, in the "Ignition on" position.