Withdrawal
1. Disconnect the cable from the throttle shaft.
2. Remove the cable sheath from the mounting bracket.
3. Remove the trim panel under the steering column.
4. Disconnect the cable from the accelerator pedal and remove the cable.
Installation
Installation is carried out in the reverse order of removal.
Adjustment
Models with manual transmission
Adjust the position of the metal clip on the cable sheath so that the throttle is fully open when the accelerator pedal is fully depressed.
Models with automatic transmission
Place a block 9 mm thick between the gas pedal and the floor and press the pedal against the block. Adjust the position of the cable sheath on the throttle body so that the throttle is fully open. Check the operation of the downshift switch.
Visitor comments