Camshaft cover (Audi A6 C4)

Table of contents: Removal ↓ Installation ↓

Removal

1. Disconnect the accelerator cable from the throttle body housing.

2. Disconnect the ventilation hose from the camshaft cover.

3. Unscrew the nuts and remove the camshaft cover.

4. Remove the gasket and the semicircular plug.

Installation

Installation is carried out in the reverse order of removal.

The article was checked by auto expert Georgy Rodionov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A6 C4: 5 cylinder engines

Additional drive belt
Timing belt tensioner, sprockets
Gas distribution belt
Timing marks for valve timing

Camshaft oil seal
Crankshaft seals
Cylinder head
Hydraulic tappets

Similar articles on other Audi car models:
Cover for transporting non-standard items Audi 80 B3 (1986-1991, petrol)
Camshaft Cover — Removal and Installation Audi 100 C3 (1982-1990, diesel)
Removal and installation the lower engine compartment cover Audi A3 Type 8L (1996-2003)
Removal and installation the upper engine cover / lower engine… Audi A4 B6 (2000-2006)
Checking the drive shaft protective cover Audi A8 D2 (1994-2002)
Removal the lower cover of the drive chains Audi Q5 Type 8R (2008-2017)
Camshaft housing — design description Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

A6(C5 AR, 1999-2005)

A6(C5, 1997-2004)

A6(C4, 1994-1997)