Rear suspension stabilizer bar (Audi A6 C4)

Table of contents: Removal ↓ Installation ↓

Removal

1. Place a jack under the rear axle.

2. Loosen the mounting nuts, remove the mounting bolts from the anti-roll bar on the left and right sides, and remove the anti-roll bar from the vehicle.

Installation

Installation is carried out in the reverse order of removal.

[This article was copied from the website «Audimanual.ru»]

The article was checked by auto expert Georgy Rodionov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A6 C4: Rear suspension

Rear suspension tie rod
Rear suspension strut
Rear wheel axle
Rear wheel hub bearings

Rear suspension cross member
Rear suspension height adjustment system
Elements of the rear suspension height adjustment system

Similar articles on other Audi car models:
Rear suspension strut / shock absorber — removal and installation Audi 80 B3 (1986-1991, petrol)
Rear suspension strut/shock absorber — removal and installation Audi 100 C3 (1982-1990, diesel)
Rear suspension device Audi A3 Type 8L (1996-2003)
Rear wheel suspension Audi A4 B6 (2000-2006)
Rear suspension wishbone Audi A8 D2 (1994-2002)
Subframe, crosspiece, stabilizer, connecting rod, subframe shield Audi Q5 Type 8R (2008-2017)
Rear suspension — general information Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

A6(C5 AR, 1999-2005)

A6(C5, 1997-2004)

A6(C4, 1994-1997)