Table of contents: Removal and installation the lever ↓ Removal and installation the… ↓
1. The installation details of the windshield wipers are shown in the illustration.
11.1. Rear window wiper installation details:
1 - Connecting tube;
2 - Nut, 8 Nm;
3 - Nozzle;
4 - Lever cover;
5 - Lever;
6 - Brush.
Removal and installation the lever
2. Carefully pry up and remove the lever cover (see illustration).
11.2. Removing the lining.
3. Carefully remove the injector (2 in the illustration) and loosen the nut (1) one turn.
11.3. Nut and nozzle.
Remove the lever using tool T10369/1 in the same way as when removing the right windshield wiper lever.
4. Installation is carried out in reverse order.
Removal and installation the electric motor
5. Remove the windshield wiper arm (see subsection above).
6. Remove the lower tailgate trim panel (see Section 10).
7. Disconnect the connector (2 in the illustration), disconnect the hose (1) from the connecting tube. Loosen the nuts (arrows) and remove the electric motor.
11.8. Removing the rear window wiper motor.
8. Installation is carried out in reverse order. Tighten the nuts to 8 Nm.
(The original material is located on the website: «audimanual.ru»)