Table of contents: Operating procedure ↓ 1. Replacing the functional unit of… ↓ 2. Installation work on the gear… ↓ 3. Replacing Mechatronics for dual… ↓ 4. Replacing the double clutch ↓
Operating procedure
The tester is connected. On the diagnostic tester in the Guided functions mode, in the folder "02 - gearbox electronics, functions", select the corresponding "Guided function". Conditions: strictly follow all instructions on the diagnostic tester to successfully complete the corresponding "Guided function". After performing the following work, it is necessary to perform the corresponding "Guided function" on the diagnostic tester.
- 1. Replacing the selector function panel: 02 - basic setting
- 2. Installation work on the selector cable drive, with adjustment of the selector cable drive: 02 - basic adjustment
- 3. Replacement of Mechatronics for gearbox with twin-disc clutch "J743" with used automatic transmission "J217": 02 - replace control unit/Mechatronics
- 4. Replacing the dual clutch, replacing the automatic transmission control unit "J217", repairing the gearbox, replacing components in the gearbox: 02 - basic setup
1. Replacing the functional unit of the gear shift mechanism
After this work, the following work steps should be performed: Select in the Guided functions mode in the catalog 02 - Gearbox electronics "Guided function" Basic setting. Select the basic setting Calibration of the speed stage sensor -G676 and follow the instructions on the tester.
2. Installation work on the gear selector cable, with adjustment of the gear selector cable
After this work, the following work steps should be performed: Select in the Guided functions mode in the catalog 02 - Gearbox Electronics "Guided function" Basic setting. Select the basic setting Calibration of the speed sensor "G676" and follow the instructions on the tester.
3. Replacing Mechatronics for dual clutch transmission "J743" with used automatic transmission "J217"
After this work, the following work steps should be performed: Select in the Guided functions mode in the catalog 02 - Gearbox Electronics "Guided function" Replacing the control unit/Mechatronics and follow the instructions on the tester.
4. Replacing the double clutch
After this work, the following work steps should be performed: Select in the Guided functions mode in the catalog 02 - Gearbox electronics "Guided function" Basic setting. Select the basic setting Adaptation of clutch grinding points and follow the instructions on the tester.
[The text is based on materials from the website: AudiManual.ru]