Withdrawal
Before removing the panel, recall from memory the errors recorded in it.
Turn off the ignition and remove the wire «masses» with battery.
Attention
- When the wires are disconnected from the battery terminals, the data on the recorded malfunctions are erased in the memory blocks of the control devices, therefore, before disconnecting the wires, it is necessary to contact the workshop to recall the malfunctions recorded in it. After connecting the wires to the battery terminals, it is necessary to activate and reprogram the power windows, as well as the position of the rear-view mirrors and seats.
- If the car has a radio with a code, then before disconnecting the wires from the terminals from the battery, check that there is a code to reactivate the receiver. Otherwise, it will be possible to put the radio receiver into operation only at a specialized station.
Remove the radio.
Remove the front center console.
Unscrew screws A (pic. 13.8) fixing the air conditioning control panel.
Pull out panel B (pic. 13.8) air conditioner control.
Release the fasteners F (pic. 13.9) and disconnect the A/B/C/D electrical connectors from the back of the A/C control panel B.
Release the latch (pic. 13.9) and disconnect electrical connector E.
Installation
Install the air conditioner control panel.
Connect the electrical connectors on the back of the panel.
Reinstall the air conditioner control panel and secure with screws.
Install the radio.
Connect wire «masses» to the battery. Repeat the operations for memorizing the position of seats, mirrors, etc., as well as set the time on the clock and enter the code into the radio.
Check the control panel coding and enter the basic installation code if necessary. If, when installing a new display, after switching on the ignition, the display lights up for two minutes, the control panel must be recoded. This work must be carried out at a service station.
Visitor comments