Unlock the circlip lock using a Torx screwdriver -arrow-.
Insert pliers into both holes -arrows- of the retaining ring. Turn the locking ring 25°counterclockwise.
I
Move the circlip into the filler neck and pull it out through the recess -arrows- of the cap.
Remove the mis-filling protection from the filler neck -arrow- and, if necessary, use circlip pliers.
Installation
Installation is in reverse order, observing the following. Install protection against incorrect filling in the filler neck. The protrusion on the mis-filling guard must fit into the groove in the filler neck -arrows-.
Install the locking ring using pliers, turning it 25°clockwise. When installed correctly, the marks on the retaining ring and the filler neck should be opposite each other -arrows-.
Visitor comments