Table of contents: All ↓ Installation ↓
Remove sound insulation.
Applies to vehicles with hydraulic power steering: Unscrew bolt "1" of the power steering line bracket. Unscrew bolts "arrow" and remove the cross connection of the braces.
Applies to vehicles with electro-mechanical power steering: Remove the electric wire on the cross-stretch "1" and "2".
Unscrew the "arrow" bolts and remove the cross-connection of the stretchers.
All
If available, remove the subframe shield on the left and right. Remove the square nuts "arrows" from the cast sockets.
Risk of damage to chassis components. Never lower the vehicle onto its wheels unless the subframe support, steering gear or subframe cross brace is properly mounted. Supporting the vehicle on the subframe or subframe cross braces (for example, when using a trolley jack, etc.) not allowed! If the car needs to be rolled, it is necessary to install the cross-connection of the braces with the old bolts and square nuts in place and tighten them to the prescribed torque without additional turning.
Installation
Installation in reverse order. The following should be taken into account: on vehicles with subframe shields, square nuts should be inserted into the casting sockets before installing the shields.