Installation
Installation is in the reverse order. In this case, it is necessary to take into account the tightening torques. The "belt" blocks have a limited working torsion range. Therefore, the bolted connections of the wheel suspension should be tightened only when the car is in the unloaded position or in the standard suspension position. Raise the wheel support with the suspension in a static position on a car with coil springs. When replacing the stabilizer, pay attention to the design of the chassis. The stabilizer and support must be degreased. Install the rubber supports with the hole in the direction of the mating surface of the subframe. Tighten nuts "1", but do not tighten. Tighten bolt connection "2" on the left and right, but do not tighten. Raise the wheel support with the suspension in a static position on a car with coil springs. Tighten bolt connections "1" and "2".