Removing the trunk lid hinge 1. Bolt. 21 Nm; 2. Trunk lid hinge. Removal: "D-pillar" removed on both sides. Remove on the appropriate side "C-pillar and safety handle. Lower the ceiling in the area of the door hinge. Remove the cover hinge trim. To avoid damage to the cover or body, support the cover and secure it from falling. Unscrew the bolts -1- of the cover. Unscrew the bolt -4-, hex nut -6- and remove the hinge. Installation: insert the hinge into the body and lightly secure it to the roof frame with a nut -6-. Then secure the hinge slightly to the side with a bolt -4-. Secure the hinge with bolts -1-. Align the cover on the left and right with the body and secure with bolts -3- with the correct torque. Adjust the height of the cover relative to the roof and tighten the bolt -4- and nut -6- to the correct torque. Install the hinge cover; 3. Trunk lid; 4. Bolt. 21 Nm; 5. Roof; 6. Nut. 21 Nm
Lid hinge trim
The cover is installed on the lid hinge. Release the side clips of the trim -2- and remove it from the cover hinge. Insert tab -arrow- behind cover. To install, place the locking tabs opposite the holes on the hinge bracket and press the pad on the opposite side.
In this case, the overlay should lock into place with a distinct click.
Visitor comments