Each main key is supplied with two disk batteries located in cover B of the transmitter body.
Remove the key.
Gently turn the screwdriver to separate the key component A from the transmitter housing B.
Remove the transmitter housing cover in the direction indicated by the arrow in Figure 1.49.
Remove the used batteries from the case cover.
Install new batteries. So install the batteries so that the markings "+" was below. The correct polarity is also indicated on the cover of the transmitter housing.
Insert the battery cover into the transmitter housing and squeeze both parts.
Insert the body of the transmitter into the key component and connect both parts until it stops.
Check the operation of the key remote control.
Visitor comments