Sealing flange and flywheel:
1. Bolt. Replace
2. Crankshaft toothed belt sprocket. There should be no oil on the mating surfaces between the toothed belt drive sprocket and the crankshaft. Installation is only possible in one position, remove after dismantling the toothed belt for the main drive
3. Crankshaft belt pulley
4. Bolt with washer for poly V-belt and toothed belt pinion for crankshaft. Replace
5. Crankshaft seal. Replace
6. Oil pump. The oil pump housing is a unit with a sealing flange on the belt pulley side. When installing, watch the hub of the driven disk on the crankshaft, it must be installed on the centering bushings
7. Seal. Replace, must be installed on centering bushings
8. Cylinder block
9. Bolt. Replace, 60 Nm + 90°
10. Flywheel
11. Intermediate shield, do not damage/bend during installation work
12. Bolt. Replace, tighten crosswise, 12 Nm
13. Sealing flange on the gearbox side with oil seal, lubricate with sealant