Remove bottom cover for toothed belt by unscrewing bolts -arrows- and opening clips.
Observe the position of the pointer -arrow on the left- of the tensioning pulley and firmly press the toothed belt -arrow on the right- with your thumb. The arrow should move to the side. Remove the load from the toothed belt again. Rotate crankshaft in direction of engine rotation 2 turns. Check the tension of the tension roller pointer. The pointer should move back to its original position. If the pointer is not in its original position, replace the tensioner.
Installation
Install in the reverse order, while installing the V-ribbed belt pulley for the crankshaft.
Visitor comments