Installing an intermediate shield (Audi A2)

Connect the upper intermediate shield to the flange "arrow A" and slide it onto the centering bushings "arrow B".

[Read the original source on the website «Audimanual.ru»]

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Sealing flange and flywheel — design description
Checking the Timing Belt Tensioner Roller for the Coupled Drive
Checking the tension roller of the toothed belt for the main…
Removal and installation a toothed belt for a coupled drive

Engine speed sensor
Replacing the crankshaft seal
Removal and installation the flywheel
Cylinder head — design description

Similar articles on other Audi car models:
Intermediate shaft — removal, inspection and installation Audi 80 B3 (1986-1991, petrol)
Piston/Connecting Rod Assemblies — Installing and Checking… Audi 100 C3 (1982-1990, diesel)
Checking, assembling and installing the connecting rod and… Audi A3 Type 8L (1996-2003)
Installing the lock bracket in the service position Audi A4 B6 (2000-2006, petrol)
Installing a Power Steering Pump Audi A6 C5 (1997-2004)
Filling the fuel system after installing the injection pump Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)