Muffler 1/13/21. Bolt. 23 Nm; 2. Suspension mount. Replace if damaged. Check pre-tension; 3. Middle muffler. At the factory it is installed as one part with the rear mufflers; in case of repair it is replaced separately. Align the exhaust system without mechanical stress; 4. Additional muffler. In the primary kit, a structural unit with a middle muffler and an end pipe. In case of repair of the additional muffler, the main muffler and the exhaust pipe are replaced separately. Align the exhaust system without mechanical stress; 5. Gasket. Replace; 6/8/12/19. Nut, 23 Nm; 7. Catalyst. Protect from impacts and shocks; 9. Gasket. Replace; 10. Intermediate muffler with detachable element; the detachable element must not be bent more than 10° - risk of damage! Align the exhaust system without mechanical aids. Double clamp, front. Align the exhaust system without mechanical stress before tightening. Tighten the connections evenly; 14. Clamp; 15. Exhaust pipe. In the factory configuration, a single unit with an additional muffler. In case of repair, it is replaced separately; 16. Suspension mount. Replace if damaged. Check pre-tension; 17. Nut. Replace, 20 Nm; 18. Rear clamp. For replacing the middle and rear mufflers separately. Before tightening, align the exhaust system without mechanical stress. Tighten the connections evenly; 20. Nut. Replace, 23 N·m; 22. Suspension mount. Replace if damaged. Check pre-tension
Individual parts of the catalytic converter fastening. Cars with dual clutch transmission 0B5 1. Nut. 23 Nm; 2. Spacer sleeve; 3. Pressure spring; 4. Washer; 5. Bolt; 6/10. Bolt. 23 Nm; 7. Spacer sleeve; 8. Buffer; 9. Overlay; 11. Holder
Individual parts for fastening the catalytic converter, cars with automatic transmission OV6 1. Nut, 23 Nm; 2. Spacer sleeve; 3. Pressure spring; 4. Washer; 5. Bolt; 6/10. Bolt, 23 Nm; 7. Spacer sleeve; 8. Buffer; 9. Overlay; 11. Holder
Note: The right suspension is shown in the picture, the left suspension is a mirror image of the right one.