Table of contents: Air flow sensor ↓ Throttle potentiometer ↓ Incoming air temperature sensor ↓ Idle speed control valve ↓ Vehicle speed sensor ↓ Fuel knock sensor ↓ Coolant temperature sensors ↓ Engine Cold start system valve ↓ Throttle body ↓ Fuel injectors and fuel rail ↓ Fuel pressure regulator ↓ Oxygen sensor ↓ Electronic control unit ↓
Air flow sensor
Removal
1. Disconnect the air hose and connection connector from the sensor.
2. Loosen the mounting screws and remove the sensor.
Installation
Installation is carried out in the reverse order of removal.
Throttle potentiometer
Removal
1. Disconnect the potentiometer connection connector.
2. Loosen the mounting screws and remove the potentiometer.
Installation
Installation is carried out in the reverse order of removal.
Incoming air temperature sensor
The temperature sensor is part of the air flow sensor and cannot be replaced separately.
Idle speed control valve
Removal
1. Disconnect the connection connector and hoses from the valve.
2. Remove the valve.
Installation
Installation is carried out in the reverse order of removal.
Vehicle speed sensor
The sensor is installed on the gearbox. See subsection 9.2.7.
Fuel knock sensor
Removal
1. Disconnect the connection connector.
2. Loosen the mounting bolt and remove the sensor.
Installation
Installation is carried out in the reverse order of removal.
Coolant temperature sensors
Coolant Temperature Sensor Location (digifant system)
The coolant temperature sensor is located on the left side of the cylinder head.
Removal
1. Disconnect the sensor connection connector.
2. Drain some of the coolant from the engine and unscrew the sensor.
Installation
Installation is carried out in the reverse order of removal.
Engine Cold start system valve
Removal
1. Disconnect the connection connector.
2. Disconnect the fuel pipe. Unscrew the mounting bolts and remove the valve.
Installation
Installation is carried out in the reverse order of removal.
Throttle body
Removal
1. Disconnect the accelerator cable.
2. Disconnect the air duct.
3. Disconnect the potentiometer connection connector and vacuum hoses.
4. Remove the top mounting screws (indicated by arrows) and remove the throttle body.
Installation
Installation is carried out in the reverse order of removal.
Fuel injectors and fuel rail
Removal
1. Disconnect the air hose from the throttle body.
2. Disconnect the accelerator cable and vacuum hoses.
3. Remove the throttle body.
4. Mark and disconnect the fuel lines and hoses.
5. Disconnect the wires from the injectors.
6. Loosen the mounting bolts and remove the fuel manifold.
Installation
Installation is carried out in the reverse order of removal.
Fuel pressure regulator
Removal
1. Disconnect the vacuum hose.
2. Remove the retaining clip and remove the regulator.
Installation
Installation is carried out in the reverse order of removal.
Oxygen sensor
Removal
1. Disconnect the connection connector.
2. Unscrew the sensor.
Installation
Installation is carried out in the reverse order of removal.
Electronic control unit
Removal
1. Remove the trim panels and the ECU cover.
2. Loosen the mounting screws and remove the electronic control unit, disconnecting the connection connector.
Installation
Installation is carried out in the reverse order of removal.