Checking the axial clearance of the camshaft (Audi A2)

Take the measurement with the tappets removed and the bearing caps installed. Attach the universal stand "VW 387" with the dial indicator "VAS 6079" to the cylinder head. Measure the axial clearance. Wear limit: 0.15 mm.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Valve mechanism — design description
Removal and installation a toothed belt with a friction-damped…
Toothed belt drive with friction damped tension roller
Removal and installation a toothed belt with a hydraulically…

Replacing the camshaft seal
Removal and installation the camshaft
Checking hydraulic tappets
Replacing valve stem seals

Similar articles on other Audi car models:
Camshaft and tappets — removal, inspection and installation Audi 80 B3 (1986-1991, petrol)
Piston/Connecting Rod Assemblies — Installing and Checking… Audi 100 C3 (1982-1990, diesel)
Checking the vehicle's readiness for operation Audi A3 Type 8L (1996-2003)
Checking the dust caps and clearance in the tie rod ends Audi A4 B5 (1994-2001, petrol)
Checking the oil level and filling Audi A6 C5 (1997-2004)
Checking the exhaust system Audi A8 D2 (1994-2002)
Camshaft chain drives Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)