Table of contents: Removal ↓ Installation ↓
Electric vacuum pump for brake system "VI92" 1. Brake vacuum pump "V192"; 2. Nut. 9 Nm; 3. Check valve; 4. Buffer; 5. Vacuum hose; 6. Bushing; 7. Bolt. 9 Nm; 8. Holder; 9. Nut. 8 Nm
The brake booster pressure sensor "G294" is installed on the brake booster.
Removal
Repair of the brake vacuum pump "V192" is not carried out. If there is an error. Replace the brake vacuum pump "V192". Brake system vacuum pump. V192- is installed in the engine compartment at the front left, next to the ABS hydraulic unit "N55". Disconnect the plug connector "1" and remove it from the retainer on the brake vacuum pump bracket "V192". Disconnect the vacuum hose "2" and remove it from the brake vacuum pump "V192".
Do not break the vacuum hose. A damaged vacuum line must be replaced. Unscrew the nuts "arrows" and remove the brake vacuum pump "V192" "1" up.
Installation
Install the brake vacuum pump "V192" "1" on the holder.
Check that the brake vacuum pump is seated correctly on the holder. The vacuum line nipple is turned in the direction of travel. Secure the brake vacuum pump "V192" using the nuts "arrows" on the holder with a tightening torque of 8 N·m. Push the vacuum hose "2" onto the vacuum line nipple until it locks into place audibly. Install the plug connector "1" into the mount on the brake vacuum pump holder "V192".