Withdrawal
1. Turn off the ignition. Disconnect wire terminal «masses» (-) from the negative pole of the battery.
2. Remove the rubber seal of the waterproof housing cover (see arrows in illustration), and then remove cover 1.
5.2. Remove the rubber seal of the waterproof cover (see arrows), and then remove cover 1
3. Unscrew the bolts (see arrows in illustration) and remove the protective cover of the fuse and relay box.
5.3. Unscrew the bolts (see arrows) and remove the protective cover of the fuse and relay box
4. Pry off the mounting bracket with a screwdriver (see arrow in illustration) and carefully remove the engine control unit from the engine compartment by disconnecting the plugs from it.
5.4. Pry off the mounting bracket with a screwdriver (see arrow)
Installation
The engine control unit is installed in the reverse order of removal.
Visitor comments