Order of execution
1. Disconnect the negative battery cable.
2. Disconnect the system power wires.
3. On models manufactured before July 1992, the connector for connecting the airbag system (indicated by an arrow) located under the center console.
4. On models manufactured between July 1992 and June 1995, the airbag connector (indicated by an arrow) located behind the glove box.
Driver airbag module
Withdrawal
1. Loosen the fixing screws.
2. Remove the airbag module and disconnect the connection connector.
Installation
Installation is carried out in the reverse order of removal.
Passenger airbag module
(models produced before July 1992)
Withdrawal
1. Remove the glovebox.
2. Loosen the mounting bracket bolts and lower the module.
3. Disconnect the connectors and remove the module.
Installation
Installation is carried out in the reverse order of removal.
Passenger airbag module
(models manufactured after July 1992)
Withdrawal
1. Remove the glove box.
2. Unscrew the fixing nuts and bolts and remove the support.
3. Disconnect the module connector.
4. Loosen the mounting bolt and remove the airbag module.
Installation
Installation is carried out in the reverse order of removal.
Electronic control unit
Withdrawal
1. Remove the center console.
2. Unscrew the fasteners (1) nuts, disconnect the connector (2) and remove the electronic control unit.
Installation
Installation is carried out in the reverse order of removal.
Contact module
Withdrawal
1. Remove the steering wheel.
2. Mark the installation position of the contact module and unscrew the fixing screws (arrows). Remove the module.
Installation
Installation is carried out in the reverse order of removal.
Air bag battery and transformer
(models up to 1993 release)
Withdrawal
1. Remove the rear seat.
2. Disconnect the connection connector, unscrew the fixing nuts/bolts and remove the module.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments