Table of contents: Removal ↓ Installation ↓
Removal
Central locking system pump
1. Remove the rear seat cushion.
2. Remove the insulator and take out the pump.
3. Disconnect the connection connector and vacuum hose and remove the pump.
Door lock drive
Look subsection 12.16.
Trunk lid lock actuator (sedan models)
1. Remove the interior trim panel.
2. Disconnect the rod from the drive.
3. Remove the mounting screws and remove the actuator, disconnecting the vacuum hose.
Trunk lid lock actuator (station wagon models)
1. Remove the trim panel.
2. Disconnect the rod from the drive.
3. Remove the mounting screws and remove the actuator, disconnecting the vacuum hose.
Fuel filler cap lock drive
1. Remove or bend the trim panel to gain access to the drive.
2. Disconnect the vacuum hose, release the retaining clip and remove the actuator.
Installation
Installation is carried out in the reverse order of removal.