Table of contents: Removal ↓ Installation ↓
Removal
1. Remove the top trim panel (the arrows show the fastening clamps).
2. Remove the side trim panels.
3. Remove the mounting screws on the sides and top of the main trim panel.
4. Unscrew the mounting screws located in the recess of the handle.
5. Remove the trim panel.
6. Remove the wire/hose bushings.
7. Disconnect the wires and remove them from the door.
8. Disconnect the vacuum hose and remove it from the door.
Models where the hinges are attached to the rear door using bolts
9. Mark the position of the hinges on the rear door.
10. Disconnect the support posts.
11. Remove the mounting bolts and remove the rear door.
Models where the hinges are attached to the rear door using nuts
Hinge fastening elements
- 1. Washers
- 2. Mounting plate
- 3. Fastening nuts
- 4. Cap
9. Remove the rear spoiler.
10. Remove the protective caps. Mark the position of the hinges on the rear door.
11. Disconnect the support posts.
12. Unscrew the mounting nuts and remove the rear door.
Installation
Installation is carried out in the reverse order of removal.
(This article was copied from an online resource: «Audimanual.ru»)