Checking the protrusion of the dowel pin from the crankshaft (Audi A2)

1. Asterisk
2. Bolt
3. The protrusion of the installation pin "3" from the crankshaft. Dimension "a" = 2.5...3.0 mm.

Check the protrusion "a" of the mounting pin with the depth gauge of the caliper when the sprocket "1" is removed.

The original article is available on the online resource audimanual.ru

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Engine repair

Removal and installation the crankshaft sprocket
Crankshaft — design description
Removal and installation the balance shaft and crankshaft frame
Balance shaft and crankshaft frame — design description

Removal and installation the drive sprocket of the chain drive
Cylinder head — design description
Removal and installation the cylinder head cover
Removal and installation of the cylinder head

Similar articles on other Audi car models:
Checking the clearances between the bearings and the crankshaft… Audi 80 B2 (1979-1986)
Crankshaft — installation and checking of working clearance Audi 100 C3 (1982-1990, diesel)
Checking the crankshaft Audi A3 Type 8L (1996-2003)
Crankshaft — checking clearances in main bearings and… Audi A4 B5 (1994-2001)
Installing and checking the crankshaft Audi A6 C4 (1994-1997)
Checking the exhaust system Audi A8 D2 (1994-2002)
Checking the fuel level sensor «G» Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)