1. Steering wheel. Secure the disconnected cable in the places marked with "arrow A"
2. Coil spring connector
3. Airbag connector
4. The internal hexagon bolt must be replaced
5. Airbag. Unlock the steering column adjustment device. Remove the steering wheel as far as possible and lift it up. Set the steering wheel vertically. Loosen the Torx screw "T30". Turn the steering wheel 1/2 turn back and disconnect the second Torx screw "T30". Disconnect connector "3" from the Airbag. Place the Airbag so that the energy-absorbing cushion is facing up. Installation: Make sure that the connectors are fully secured (with an audible click). After connecting the battery terminals, ensure that the vehicle's equipment has been checked. If the Airbag fault indicator lamp (K 75) signals an error after installation, the fault memory data must be erased using the VAS 5051 A tester and the fault memory must be interrogated again
6. Threaded bushing
7. Torx screws (T30), 7 Nm
8. Torx key (T30)
9. Return ring with slip ring
10. Steering wheel heating connector