1. Used Airbag. Disconnect the negative terminal/cable of the battery. Remove the rear part of the center console. Rearrange the safety clip "4" in the connector "3". Disconnect the connector "3" of the control unit. Unscrew the screws "2" (3 pcs.). Remove the control unit
2. Bolts (3 pcs.), tightening torque 7 Nm
3. Connector
4. Fixing loop
Instructions. When replacing the control unit, change the coding. After connecting the battery terminals, ensure that the vehicle's equipment has been checked. If the Airbag fault indicator lamp (K 75) signals an error after installation, the fault memory data must be erased using the IMS 5051 A tester and the fault memory must be interrogated again.