Table of contents: Removal ↓ Installation ↓
Removal
Fold both backrests forward.
Remove plug 3 (fig. 12.107) from below, use the hole at the bottom if necessary.
Remove bolt 1 (fig. 12.107) and remove clamp 2.
Raise the back 1 (fig. 12.108) from the middle support 2, arrow A, and remove it from the fastening part 3, arrow B. If the tip 4 is removed at the same time, be sure to put it back in place.
If necessary, disconnect the electrical connector from the backrest heating.
Installation
Installation is performed in the reverse order of removal. Screw the clamp with a bolt and tighten it to a torque of 8 Nm.