Table of contents: Removal ↓ Installation ↓
If the ignition system indicator light does not come on when the ignition is turned on, check the connecting wires, the bulb itself and the socket.
If the warning light comes on while the engine is running, turn off the engine and check the drive belt tension, the generator connecting wires and the condition of the generator itself. Check the voltage stabilizer. If you are unable to detect the fault, contact a specialist.
Removal
1. Remove the alternator drive belt.
2. Disconnect the wires from the generator.
3. Unscrew the lower mounting bolt and nut (on AAT engines).
4. Remove the upper generator mounting bolt.
5. Remove the generator.
Installation
Installation is carried out in the reverse order of removal. Tighten the mounting bolts to the required tightening torque.