Withdrawal
Engine or gearbox removed. Remove the clutch basket. Mark the position of the dual-mass flywheel in relation to the crankshaft.
Instruction. In order to be able to use the locking pin -3386-, it must be able to move freely along the axis.
Remove the circlip -arrow- to enable the locking pin to move axially. Insert tool -3386- to loosen bolts. Loosen the dual-mass flywheel.
Installation
Install in reverse order, replacing the dual-mass flywheel bolts. Reposition clamp -3386- to tighten bolts. Install the clutch basket.
Torque:
- Dual mass flywheel to crankshaft 60 Nm + 90°1)
- Bolt length: 19.5mm
1) Replace bolts.
Visitor comments