Table of contents: Remove the headrest guides ↓ Installation of edging ↓
1. Seat back cover. Remove the seat back cover "5" from the bottom. Remove the clamping strip "6" from the left and right bottom. Remove the keder "3" from the clamping strip "2" from the left and right sides. Fold it up from the seat back. Cut the wire staples "8" (2x). Remove the seat back cover "1" with the cushion up
2. Clamping bar
3. Edging
4. Side Airbag cable
5. Backrest pad
6. Clamping bar
7. Spring gasket
8. Wire staples
Remove the headrest guides
For greater clarity, the headrest guide "1" is shown in the removed state. Insert a saddle needle or a screwdriver "3" no more than 2 mm wide into the hole "4" (hole "4" is opposite the headrest guide clamp). Raise the screwdriver "3" in the direction indicated by the arrow "A" and press the locking lug "2" in the direction indicated by the arrow "B", while removing the headrest guide "1".
Installation of edging
Place cutout "3" of edging "2" against groove "4" in seat back covering "1".