Table of contents: With durable back cover ↓ With seat back upholstery material ↓
With durable back cover
1. Seat back cover. Remove the seat. Remove the seat back, remove the side Airbag module. Press the upholstery clamp bar out of the backrest insert "7". Detach the backrest cover "7" from the clamp "6". Remove the backrest cover "7". Remove the rear backrest cover. Remove the headrest "8" by pressing the button on the left rod. Remove the headrest guide "9". Lift the upholstery and cut the wire clips "5" "A". Remove the cushion "2". Installation: On vehicles with a side Airbag, the upholstery must be cut out. Apply the cut in the keder to the groove of the seat back cover. Use staple pliers to install new wire clips "V.A.G 1634". For more convenient installation, move the longitudinal rods back to the first cross rod. When installing, fasten the cross rods first with clamps, then the longitudinal rods
2. Pillow
3. Seat back heating. Seat back heater and upholstery, spare part. On cars with seat back heater, the upholstery should be changed together. On cars without seat back heater, cable "4" should be cut
4. Seat back heating cable
5. Wire staples
6. Clamp
7. Backrest pad
8. Headrest The headrest is non-detachable, upholstery and cushion, spare part. The rear outer headrest is not identical to the front headrest. When removing any headrests, mark the headrests with adhesive tape
9. Headrest guide
With seat back upholstery material
1. Seat back cover. Remove the seat. Remove the seat back. Remove the side Airbag module. Remove the headrest "6" by pressing the button on the left guide. Remove the headrest guide "7". Open the seat back cover upholstery. Lift the upholstery and cut the wire staples "5" "A". Remove the cushion "2". Installation: On vehicles with a side Airbag, the upholstery must be cut out. Use staple pliers to install new wire staples "V.A.C-1634/". For more convenient installation, move the longitudinal rods back to the first cross rod! When installing, fasten the cross rods first with clamps, then the longitudinal rods
2. Pillow
3. Seat back heating. Seat back heater and upholstery. spare part. On cars with seat back heater, the upholstery should be changed together. On cars without seat back heater, cable "4" should be cut
4. Seat back heating cable
5. Wire staples
6. Headrest. The headrest is non-separable, upholstery and cushion. spare part. The rear outer headrest is not identical to the front headrest. When removing any headrests, mark the headrests with adhesive tape
7. Headrest guide
[Read the original source on the website audimanual.ru]