Front seat back 1. Seat base; 2. Bolts. 33 Nm. Self-locking. After each replacement, the threaded holes for the bolts should be cleaned, for example, using a thread cutter; 3. Back; 4. Headrest; 5. Wire harness, stretched from the side Airbag to the connection module. Depending on the version of the set. There may be other wiring harnesses available, for example, heated seats, lumbar support systems; 6. Bolts. 33 Nm. Self-locking. Replace after each removal. Threaded holes for bolts should be cleaned, e.g. using a thread cutter
DVD player mounting plate tightening torque:
- Tighten the screws -2- of the mounting plate to a torque of 6 Nm.
DVD player support sleeve tightening torque:
- Tighten nut -2- to 0.4 Nm.
Removing the backrest pad
Removal can be carried out on the installed seat. Removal and installation of the backrest is described for a standard front seat. The execution of the part is similar to the parts on other seat options. A description of the kit option is given. without luggage net. The luggage net cannot be removed from the seatback pad and can only be replaced together with the seatback pad. To do this, grasp the seat backrest trim -1 - from the rear, as shown in the illustration, and remove it from the right side of the seat backrest -2-.
If there is difficulty, use the release lever -80-200-. Repeat these operations on the opposite side. To do this, release the side locking lugs. Continue removing the backrest cover and bend it back until the lower hooks are released from the backrest frame. Remove the backrest trim downwards.
Installation
Installation in reverse order: first push the upper clips -2- under the upper cross member of the backrest. Move the seat backrest trim downwards and secure the side locking tabs -3- and -5- as well as the lower hooks -4-. Make sure that the side fixing lugs are correctly secured to the backrest frame and the position of the lower hooks on the backrest frame.
Press the backrest pad firmly in the places marked with -arrows- in the direction of the backrest. Make sure that the backrest trim is properly secured. The lower part of the seat backrest must not be removed.
Visitor comments