Removing upholstery and cushion
The back of the rear seat in the disassembled state should not be folded back, as it happens when it is installed, damage to the upholstery linings may occur.
1. Upholstery. Remove rear seat. Unlock the rear seat back. Using a flat-bladed screwdriver, pry out the edging -2- around the perimeter. Remove upholstered pillow
2. Edging
3. Seat back cover
4. Isofix
Removing the upholstery from the pillow
1. Upholstery. Detach clips -4- from cushion -2-. Cut through the wire clips -3- and remove the seat upholstery. Installing: Use clip pliers -VAG 1634/- to install new wire clips. For easier installation, move the longitudinal rods back to the first transverse rod. When installing, clamp first the transverse and then the longitudinal rods
2. Pillow
3. Wire staples
4. Staples. Standard, according to the tacker manufacturer's data. Only use a cushion staple tacker.
5. Isofix groove
Visitor comments