Table of contents: Removal the upholstery and cushion ↓ Removal the upholstery from the… ↓
Removal the upholstery and cushion
To prevent damage to the upholstery trims, the rear seat backrest should not be reclined further when disassembled than when installed.
1. Edging
2. Edging around the perimeter
3. Handrails (2x)
4. Upholstery. Remove the rear seat. Unlock the back of the rear seat. Press the edging with a flat screwdriver. Press the edging "2" along the perimeter with a flat screwdriver. Remove the trim from the handrails "3" (2x). Remove the upholstery and cushion "4". Installation: Install the upholstery and cushion "4" in the opposite order of removal
Removal the upholstery from the cushion
1. Upholstery. Disconnect clips -2 from cushion "3". Cut wire staples "4" and remove upholstery. Installation: Use staple pliers to install new wire staples "V.A.G 1634/". For more convenient installation, move the longitudinal rods back to the first cross rod. When installing, fasten the cross rods first with clamps, then the longitudinal rods
2. Staples. Standard, according to the manufacturer's data. Use only the stapler for pillow staples
3. Pillow
4. Wire staples