Bottom lining (Audi Q5-8R)

Front noise insulation 1. Soundproofing casing. Removal: the front wheel spoiler is removed. Unscrew bolts "1" and "2", as well as the bolts on the bottom of the mudguard (3 pcs on each side) and remove the body insulation in the rear direction under the bumper. When installing, the front noise insulation must be installed under the bumper; 2. Bumper trim; 3. Bracket. Slide onto the bumper cover; 4. Bolt 2.5 Nm; 5. Quick release clamp. To remove, turn 180° to the left. When installed, the clamp should click into place.; 6. Soundproofing screen, rear; 7. Bolt. 2.5 Nm; 8. Spoiler

Rear noise insulation 1. Soundproofing screen, rear. On the soundproofing, unscrew the 3 rear quick-release clamps. Unscrew the quick-release clamps "6" and remove in the rear direction; 2. Block of crossing stretchers; 3. Bracket. Insert from the side into the crossmember of the gearbox; 4. Washer; 5. Quick release clamp. To remove, turn 180° to the left. When installed, the clamp should click into place; 6. Bracket. Enter the block of intersecting stretchers

Aerodynamic shield, front 1. Aerodynamic shield, right; 2. Expansion piston; 3. Nut. 2 Nm; 4. Expansion piston; 5. Aerodynamic shield, front right; 6. Aerodynamic shield, front left; 7. Aerodynamic shield, left

Aerodynamic shield, rear 1. Bolt 2 Nm; 2. Aerodynamic shield, rear right. When installing, insert under the right aerodynamic shield; 3. Nut. 2 Nm; 4. Clamp 3 Nm; 5. Right rear threshold trim; 6. Aerodynamic shield, rear left; 7. Bracket; 8. Left rear threshold trim

Heat shield underbody, front 1. Heat shield, front; 2. Clamping washer. When removing, unscrew; when installing clamping washers, just press them down; 3. Bottom sheet; 4. Heat shield, central

I 1. Right heat shield; 2. Heat shield of the main muffler; 3. Rear of the body; 4. Clamping washer. When removing, unscrew, when installing, just press; 5. Left heat shield

Tunnel crossbar 1. Bolt 55 Nm; 2. Crossbar, front; 3. Stretching; 4. Nut. 20 Nm; 5. Crossbar, rear; 6. Bolts. 55 Nm