Table of contents: Poor glass cleaning quality.… ↓ The remaining water in the cleaning… ↓ The brush works one-sidedly ↓ There are still some uncleaned… ↓
Poor glass cleaning quality. Smudges, smears
The rubber band is dirty
Clean the rubber band with a hard nylon brush and detergent or alcohol.
Fringe on the working surface of the rubber belt. The belt is torn or worn out
Replace the rubber band.
Aging rubber band. Cracked surface
Replace the rubber band.
The remaining water in the cleaning zone is collected into beads
The glass is oily or contaminated with polish
Clean the glass with a clean cloth and a silicone-based grease and oil stain remover.
The brush works one-sidedly
One half of the cleaning area is cleaned well, and the other half poorly. The brush vibrates during operation. Deformation of the rubber band.
The working surface of the tape does not rotate to the other edge
Install a new rubber band.
The wiper arm is displaced. The wiper blade does not adhere to the glass
Carefully adjust the position of the brush lever.
There are still some uncleaned places left
The rubber band has come out of the mount
Carefully feed the tape into the holder.
The rubber band does not fit evenly to the glass because the holders are bent
Replace the rubber band. This malfunction usually occurs when the replacement brush is installed improperly.
Weak lever clamping force
Lubricate the lever pivots and springs or install a new lever.
[This article was previously published on the resource: AudiManual.ru]